Hi Guys,
Looking for ROM for MHT2040AT xx5C-0022 (xx=don't care)
Or a drive/PCB with this version I can buy/beg/borrow?
Cheers!
| HDD GURU FORUMS http://forum.hddguru.com/ |
|
| Fujitsu ROM or PCB required http://forum.hddguru.com/viewtopic.php?f=11&t=19406 |
Page 1 of 1 |
| Author: | pcimage [ May 14th, 2011, 12:20 ] |
| Post subject: | Fujitsu ROM or PCB required |
Hi Guys, Looking for ROM for MHT2040AT xx5C-0022 (xx=don't care) Or a drive/PCB with this version I can buy/beg/borrow? Cheers! |
|
| Author: | nande [ May 14th, 2011, 19:04 ] |
| Post subject: | Re: Fujitsu ROM or PCB required |
Fujitsu MHT code should be xYYx - 0022. x don't care, Y needed. If you give me that code, I can send you the ROM. |
|
| Author: | pcimage [ May 16th, 2011, 4:03 ] |
| Post subject: | Re: Fujitsu ROM or PCB required |
Thanks for the reply. I've always match xxYY-0022 before and it's been OK, maybe I've been lucky! My full FW version is 0B5C-0022 Cheers!! |
|
| Author: | nande [ May 16th, 2011, 5:03 ] | ||
| Post subject: | Re: Fujitsu ROM or PCB required | ||
Here it is. xxYY - YYYY works up to MHS, but not so sure... MHT is xYYx -YYYY. Rgds,
|
|||
| Author: | pcimage [ May 16th, 2011, 6:20 ] |
| Post subject: | Re: Fujitsu ROM or PCB required |
Thanks! Strange thing is that it's identical to the one I read off the original dead PCB, which I had assumed was corrupt and was killing every PCB I wrote it too. Further investigation revealed that it was ATA0 on the UDMA I was using, it was corrupting data when writing the ROM, tried again using ATA1 and it worked fine. Data recovering now! Many thanks, I owe you one!! |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|
