| HDD GURU FORUMS http://forum.hddguru.com/ |
|
| Toshiba MQ01ABD050 BSY http://forum.hddguru.com/viewtopic.php?f=11&t=28839 |
Page 1 of 1 |
| Author: | pclab [ June 13th, 2014, 14:40 ] |
| Post subject: | Toshiba MQ01ABD050 BSY |
Hi Got this drive that can't ID... After power on I get this: Techno On............................... : Drive is not ready Zone table.............................. : Zone table read error; Drive is not ready G-List reading error.................... : G-List read error; Drive is not ready CP Avalable............................. : 33,34,44,56,92,95,98,9A,9C,A2,A5,A7,A8,A9,AA,AD,AE ,B1,B3,BB,BF,C1,C5,C6,C7,C8,C9,CB,CD,D0,D1,D3,D4,D 6,D7,D9,DA,DB,DC,DD,EF,F1,F3,F4,F7,F8,FA,FB,FC,FF The drive tries to calibrate (some very low noises) and sometimes can get Ready, other times, stay Busy. Can this be only the G-list error? I have tried to clean it, but I always get the drive Busy.... Thank You |
|
| Author: | MindMergepk [ June 13th, 2014, 17:04 ] |
| Post subject: | Re: Toshiba MQ01ABD050 BSY |
Have you tried isolating Head Contacts ? |
|
| Author: | pclab [ June 17th, 2014, 8:01 ] |
| Post subject: | Re: Toshiba MQ01ABD050 BSY |
Yes, didn't helped... |
|
| Author: | MindMergepk [ June 17th, 2014, 8:10 ] |
| Post subject: | Re: Toshiba MQ01ABD050 BSY |
than most likely, media or head problem |
|
| Author: | waqas_ali766 [ June 17th, 2014, 8:29 ] |
| Post subject: | Re: Toshiba MQ01ABD050 BSY |
Hello, The Toshiba hdd stay busy because of continuous reading of bad area (Bad sector ) and assign it. when the damaged sector is read able then the hdd shows you ready status, some time it take about 30 minutes to become ready. after ready clear G list and extract data by cloning through MRT or pc3000. Some times head or sub zones are damaged that's why it stay busy fro about 30 minute. Regards Waqas Ali |
|
| Author: | pclab [ June 17th, 2014, 13:12 ] |
| Post subject: | Re: Toshiba MQ01ABD050 BSY |
This is a FW problem (translator...) If I read thru utility on PC3K I can access data. The problem is that I don't have DE.... Still working on it. |
|
| Author: | pclab [ June 17th, 2014, 15:02 ] |
| Post subject: | Re: Toshiba MQ01ABD050 BSY |
Got it imaging finally eheheh |
|
| Author: | Nick_CT [ June 23rd, 2014, 4:55 ] |
| Post subject: | Re: Toshiba MQ01ABD050 BSY |
Are you sure this was translator issue? |
|
| Author: | pclab [ July 1st, 2014, 5:32 ] |
| Post subject: | Re: Toshiba MQ01ABD050 BSY |
Yes, the case was closed with 100% recovery. At least with this solution I could get the data. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|