HDD GURU FORUMS

Hi gurus,

I'm looking a loader to WD3200BEVT-60ZCT1 Denali.

Techno mode key
Techno mode key......................... : Ok

RAM:
HDD Info reading........................ : Ok
Heads number............................ : 4
Cyl Count............................... : 128

ROM:
ROM reading............................. : Ok
ROM Data size........................... : 192 Kb
ROM version............................. : 08.30D
ROM generation.......................... : 08.30D
Link table version...................... : 02.14.
Consolidated ROM version................ : 00080030

ROM Modules:
Flash ROM dir reading................... : Ok
SA regions address...................... : by default
SA Translator loading................... : Ok
SA defects assigned..................... : 8

Heads configuration..................... : by map
Heads number............................ : 4
Heads number in use..................... : 4
Switched off heads...................... : No
Heads map............................... : 0,1,2,3
ROM Firmware version.................... : 00080030

Thank you all for your time and support!

>Techno mode key
>Techno mode key......................... : Ok
>
>RAM:
>HDD Info reading........................ : Ok
>Heads number............................ : 4
>Cyl Count............................... : 128
>
>Zone allocation table................... : Ok
>SA SPT.................................. : 693
>
>ROM:
>ROM reading............................. : Ok
>ROM Data size........................... : 192 Kb
>ROM version............................. : 08.31D
>ROM generation.......................... : 08.31D
>Link table version...................... : 02.14.
>Consolidated ROM version................ : 00080031
>
>ROM Modules:
>Flash ROM dir reading................... : Ok
>SA regions address...................... : by default
>SA Translator loading................... : Ok
>
>Heads configuration..................... : by map
>Heads number............................ : 4
>Heads number in use..................... : 4
>Switched off heads...................... : No
>Heads map............................... : 0,1,2,3
>ROM Firmware version.................... : 00080031
>
>Service area:
>Permanent overlay....................... : Loaded
>SA dir reading (ID)..................... : Ok
>SA Access............................... : Copy 0,Copy 1
>


Hello. Is this going to help you ? slight difference

Here's Version 00080030 from an 80Gb drive, should work....

Thank you all, public and private messages were helpful. This one turned out to be bad head(s) though.