HDD GURU FORUMS
http://forum.hddguru.com/

PC USB Terminal Connection
http://forum.hddguru.com/viewtopic.php?f=11&t=30728
Page 1 of 1

Author:  Juyoung [ March 16th, 2015, 5:26 ]
Post subject:  PC USB Terminal Connection

Hi, PC3000 cannot auto-detect my seagate hdd.

So I found the link from hddguru forum (viewtopic.php?t=7084&start=)

I set it up following pcimage in the link, (he said "If you have it setup Ok, the +5V light (red) and the RxD light (yellow) should both be on, and when you apply power to the HDD the RxD light will go off then start to flicker as the drive sends data through the serial port")

Attachment:
KakaoTalk_20150316_175949251.jpg
KakaoTalk_20150316_175949251.jpg [ 70.8 KiB | Viewed 8162 times ]

Attachment:
KakaoTalk_20150316_175949196.jpg
KakaoTalk_20150316_175949196.jpg [ 68.71 KiB | Viewed 8162 times ]


But in my case, it is not working.

And both COM port setting and setting in PC3000 look fine.

Attachment:
com43.png
com43.png [ 864 Bytes | Viewed 8162 times ]

Attachment:
setting.png
setting.png [ 1.6 KiB | Viewed 8162 times ]


Plz help me.

Author:  MindMergepk [ March 16th, 2015, 7:26 ]
Post subject:  Re: PC USB Terminal Connection

you did't follow it correctly. check the direction of the cable when connecting to the connector

Attachments:
KakaoTalk_20150316_175949196.jpg
KakaoTalk_20150316_175949196.jpg [ 88.62 KiB | Viewed 8147 times ]

Author:  labtech [ March 16th, 2015, 8:53 ]
Post subject:  Re: PC USB Terminal Connection

+1, yep, gray cable connector needs to be reversed.

Author:  Kum Ruzvelt [ March 17th, 2015, 6:22 ]
Post subject:  Re: PC USB Terminal Connection

Should be a better picture in the manual.
Like MindMergepk and labtech say is correct way.

Author:  Juyoung [ March 18th, 2015, 2:16 ]
Post subject:  Re: PC USB Terminal Connection

I corrected the position of the grey cable like you guys suggested, but my hdd is still not detected on PC-3000.

So, I tried to connect to COM port using hyper terminal.

When I turn on hdd, I got following message.

Attachment:
hyper terminal output.png
hyper terminal output.png [ 17.11 KiB | Viewed 8032 times ]


Does it mean there is not any problems with PC USB Terminal connection??

What is weird is the terminal messages don't always appear.

I kept connecting and disconnecting hdd power cable, and sometimes the messages are printed.

Author:  labtech [ March 19th, 2015, 10:24 ]
Post subject:  Re: PC USB Terminal Connection

Terminal is fine.
Problem is with drive's firmware.

Suggestion: when you are unsure whether your terminal works correctly or not, test with another drive to confirm terminal config is good.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/