Hello every body , this my first topic on this site
I am new in data recovery field and using PC3k UDMA , i have a WD5000BMVW-11AMCS0 Family:zephyr with USB PCB the hdd not recognized i swapped the PCB from (USB 2060-771737 To SATA 2060-771692) so i can connect it to the pc3K and sure swapped the U12 ROM
the problem is when i initialize the utility the following error popup:
Techno mode key
Techno mode key......................... : Ok
RAM:
HDD Info reading........................ : Ok
Heads number............................ : 4
Cyl Count............................... : 256
Zone allocation table................... : HDDs RAM reading error - Device Error Detected: "VSCE PERM OVL NOT LOADED. LDR Upload is recomended"
ROM:
ROM reading............................. : Ok
ROM Data size........................... : 256 Kb
Flash ROM dir reading................... : Ok
SA regions address...................... : by default
SA Translator loading................... : Ok
ROM Modules:
ROM version............................. : 10.19A
ROM F/W version......................... : 00100019
Overlay F/W version..................... : 10.19A
Servo F/W version....................... : 02.17
Heads configuration..................... : by map
Heads number............................ : 4
Heads number in use..................... : 4
Switched off heads...................... : No
Heads map............................... : 0,1,2,3
Service area:
Permanent overlay....................... : Not loaded
SA dir reading (ID)..................... : Drive is not ready
SA dir reading (ABA/CHS)................ : Techno key error; unexpected error: Operation aborted
i think need the LDR File
any help would be appreciated
many thanks
| Attachments: |
|
Untitled.jpg [ 202.52 KiB | Viewed 6903 times ] |