Wrong SN and LBA

[LostDataSa]

hi i have WD 1TB, the drive spin fine but i get these

Model : WDC WD10EZRX-00A8LB0
Serial : WDC-ROM SN# XYZ----
Firmware : 01.01A01
Capacity : MB (1)


the model is correct

when i choose Utility Statues I get the correct info also when choosing "Edit HDD ID" i get the correct SN and LBA.

What seems to be the problem ?



Techno mode key
Techno mode key......................... : Ok

RAM:
HDD Info reading........................ : Ok
Heads number............................ : 2
Cyl Count............................... : 256

Zone allocation table................... : Ok
SA SPT.................................. : 1682

ROM:
ROM reading............................. : Ok
ROM Data size........................... : 256 Kb
Flash ROM dir reading................... : Ok (Active)
Flash ROM dir reading (Ext)............. : Ok
Modules directory address............... : 93 026
SA regions address...................... : by default
SA Translator loading................... : Ok

ROM Modules:
ROM version............................. : 65.18J
ROM F/W version......................... : 00650018
Overlay F/W version..................... : 65.19J
Servo F/W version....................... : 38.02

Heads configuration..................... : by map
Heads number............................ : 2
Heads number in use..................... : 2
Switched off heads...................... : No
Heads map............................... : 0,1

Service area:
Permanent overlay....................... : Loaded
SA dir reading (ID)..................... : Ok
SA Access............................... : Copy 0,Copy 1

Configuration reading................... : Ok
Master Password......................... : has not been set
User Password........................... : has not been set

HDD ID reading.......................... : Ok
Heads test
Cylinder to test........................ : -10
Heads to test........................... : 0,1
Head 0.................................. : Ok
Head 1.................................. : OK

Attachments

[northwind]

Mod02?
Modules OK?

[pcimage]

Show results of SA module check

[LostDataSa]

109
FA
6F
6A
69
43
12
04

These models are bad

[pcimage]

Try and read the mods by composite read, to see if you can get one good copy.

Most of those mods aren't important.

[LostDataSa]

Try and read the mods by composite read, to see if you can get one good copy.

Most of those mods aren't important.

i found a donor HDA and i replaced all dead models and it works fin now

thank you all

[jermy]

i found a donor HDA and i replaced all dead models and it works fin now

you copied mod 43 from donor to patient ?