hi i have WD 1TB, the drive spin fine but i get these

Model : WDC WD10EZRX-00A8LB0
Serial : WDC-ROM SN# XYZ----
Firmware : 01.01A01
Capacity : MB (1)


the model is correct

when i choose Utility Statues I get the correct info also when choosing "Edit HDD ID" i get the correct SN and LBA.

What seems to be the problem ?



Techno mode key
Techno mode key......................... : Ok

RAM:
HDD Info reading........................ : Ok
Heads number............................ : 2
Cyl Count............................... : 256

Zone allocation table................... : Ok
SA SPT.................................. : 1682

ROM:
ROM reading............................. : Ok
ROM Data size........................... : 256 Kb
Flash ROM dir reading................... : Ok (Active)
Flash ROM dir reading (Ext)............. : Ok
Modules directory address............... : 93 026
SA regions address...................... : by default
SA Translator loading................... : Ok

ROM Modules:
ROM version............................. : 65.18J
ROM F/W version......................... : 00650018
Overlay F/W version..................... : 65.19J
Servo F/W version....................... : 38.02

Heads configuration..................... : by map
Heads number............................ : 2
Heads number in use..................... : 2
Switched off heads...................... : No
Heads map............................... : 0,1

Service area:
Permanent overlay....................... : Loaded
SA dir reading (ID)..................... : Ok
SA Access............................... : Copy 0,Copy 1

Configuration reading................... : Ok
Master Password......................... : has not been set
User Password........................... : has not been set

HDD ID reading.......................... : Ok
Heads test
Cylinder to test........................ : -10
Heads to test........................... : 0,1
Head 0.................................. : Ok
Head 1.................................. : OK

Mod02?
Modules OK?

_________________
http://www.northwind.gr
SandForce SSD Recovery
Ransomware Reverse Engineering - NoMoreRansom! partners

ROM match overlay ? Non-Native ROM ?

All modules check OK ?

_________________
1Q9xrDTzTddUXeJAFRn37aqh1Yr6buDCdw - (Bitcoin Donations)
paypal.me/Spildit - (PayPal Donations)
The HDD Oracle - Platform for OPEN research on Data Recovery.

Show results of SA module check

_________________
PC Image Data Recovery
http://www.pcimage.co.uk

New!! HDD-PCB.COM for all your PCB and donor HDD requirements!

109
FA
6F
6A
69
43
12
04

These models are bad

Try and read the mods by composite read, to see if you can get one good copy.

Most of those mods aren't important.

_________________
PC Image Data Recovery
http://www.pcimage.co.uk

New!! HDD-PCB.COM for all your PCB and donor HDD requirements!

i found a donor HDA and i replaced all dead models and it works fin now

thank you all

Cool !

_________________
1Q9xrDTzTddUXeJAFRn37aqh1Yr6buDCdw - (Bitcoin Donations)
paypal.me/Spildit - (PayPal Donations)
The HDD Oracle - Platform for OPEN research on Data Recovery.

you copied mod 43 from donor to patient ?