HDD GURU FORUMS

anyone can share the Mod: 11 for the below ROM from a Fblite Family:

ROM Modules:
ROM version............................. : 16.7CG
ROM F/W version......................... : 0016007C
Overlay F/W version..................... : 16.7CG
Servo F/W version....................... : N0.41

Heads configuration..................... : by map
Heads number............................ : 4
Heads number in use..................... : 4
Switched off heads...................... : No
Heads map............................... : 0,1,2,3

thanks in advance

there are many available but Overlay F/W version..................... : 16.7DG whereas I need Overlay F/W version..................... : 16.7CG exactly.

desperately need this, anybody ??

Model: WD10JPVX-22JC3T0

ROM Modules:
ROM version............................. : 16.7CG
ROM F/W version......................... : 0016007C
Overlay F/W version..................... : 16.7CG
Servo F/W version....................... : N0.41

Heads configuration..................... : by map
Heads number............................ : 4
Heads number in use..................... : 4
Switched off heads...................... : No
Heads map............................... : 0,1,2,3

I don't understand why these questions come up so frequently. AISI, the simple solution would be as follows.

Obtain a matching ROM/loader combination, of any firmware version, for the patient drive.

Patch the patient's adaptives into the donor ROM.

Start patient drive with donor's ROM and loader.

Retrieve native loader from SA.

Restore patient ROM.

Of course I'm assuming that the native loader is not damaged.

fzabkar wrote:Of course I'm assuming that the native loader is not damaged.

your assumption is not correct, the native mod 11 is damage, infact drive has media scratch managed to extract the FW except mod 11, which is now required to do a smart hot swap.

thanks for the reply.

anyone ?

thanks

AIUI, there are 4 copies of this module.

Hi,
For FBLite, the overlay version is always 1 larger than the ROM version !!!
ROM and Overlay for FBLite are always available in two versions for SA SPT 1437, and for SA SPT 1480
Version with G at the end is for SA SPT 1437
Version with H at the end is for SA SPT 1480

Code:

>SA SPT.................................. : 1437
>
>ROM:
>ROM reading............................. : Ok
>ROM Data size........................... : 256 Kb
>ROM version............................. : 16.7CG
>ROM generation.......................... : 16.7DG
>Link table version...................... : N0.41.
>Consolidated ROM version................ : 0016007C

Code:

>SA SPT.................................. : 1480
...
>ROM Modules:
>ROM version............................. : 16.7CH
>ROM F/W version......................... : 0016007C
>Overlay F/W version..................... : 16.7DH
>Servo F/W version....................... : N0.41

If Overlay is not loaded into memory then the Overlay version will be equal to the ROM version as here

Code:

ROM Modules:
ROM version............................. : 16.7CG
ROM F/W version......................... : 0016007C
Overlay F/W version..................... : 16.7CG
Servo F/W version....................... : N0.41

Mikippp

thanks alot. Mikippp