All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 23 posts ]  Go to page Previous  1, 2
Author Message
 Post subject: Re: WD my book encryption
PostPosted: January 28th, 2021, 22:39 
Offline

Joined: January 28th, 2021, 8:02
Posts: 4
Location: Hong Kong
After going through the topics and trace a little bit on the circuit it's found that the step down at U3 (RT8060A) was damaged. the Vin stays with 5V but no output. I'm going to replace it and see if it works...


Top
 Profile  
 
 Post subject: Re: WD my book encryption
PostPosted: January 29th, 2021, 9:43 
Offline

Joined: January 28th, 2021, 8:02
Posts: 4
Location: Hong Kong
no success after switching U3 by putting the same component from a donor board. There's voltage outputting from the U3 now but it's as low as 0.9v. Suppose to be 2.5v. :( Any ideas?


Top
 Profile  
 
 Post subject: Re: WD my book encryption
PostPosted: January 29th, 2021, 10:51 
Offline

Joined: January 28th, 2021, 8:02
Posts: 4
Location: Hong Kong
Nevermind
It was bad soldering
Reapply solder again and drive came back to live!!! Yay!!


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 23 posts ]  Go to page Previous  1, 2

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 16 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group