Page 1 of 1
What technically happen if m0,2,2 etc command interrupted?
Posted: October 14th, 2020, 9:22
by smecca
Hi guys, have a .11 drive with simple busy/lba problems.
After execute g-lits command rebuild via m0 command, several days has spent without terminal reply.
Now I was wondering what happen if i break this operation?
PS: have fully backed up mods before
Re: What technically happen if m0,2,2 etc command interrupte
Posted: October 14th, 2020, 10:16
by pepe
You don't seem to have any other chance interrupting that operation (it probably hung somewhere already so it's not doing anything at the moment).
btw, m0 does not rebuild glist, I'm afraid you are not really certain about these things, are you?
pepe
Re: What technically happen if m0,2,2 etc command interrupte
Posted: October 14th, 2020, 10:45
by smecca
pepe wrote:btw, m0 does not rebuild glist, I'm afraid you are not really certain about these things, are you?
pepe
I mean Trasl recalc. is this ok?
Re: What technically happen if m0,2,2 etc command interrupte
Posted: October 14th, 2020, 10:47
by smecca
smecca wrote:pepe wrote:btw, m0 does not rebuild glist, I'm afraid you are not really certain about these things, are you?
pepe
I mean Trasl recalc. is this ok?
Re: What technically happen if m0,2,2 etc command interrupte
Posted: October 15th, 2020, 3:27
by pepe
yep, that's better
you could turn on 'additional diag messages' to see where it gets stuck.
pepe
Re: What technically happen if m0,2,2 etc command interrupte
Posted: October 15th, 2020, 4:25
by smecca
Thank you Pepe, thats a good idea.
I will stop current operation for tomorrow, whatever it happens, and then I'll analize deeper termnal output.