| HDD GURU FORUMS http://forum.hddguru.com/ |
|
| WD10JPCX-24UE4T0 / ROM FW 0016007C http://forum.hddguru.com/viewtopic.php?f=11&t=40607 |
Page 1 of 1 |
| Author: | datarikaviri [ November 16th, 2020, 6:49 ] |
| Post subject: | WD10JPCX-24UE4T0 / ROM FW 0016007C |
Hello everybody; I have uploaded compatible LDR&DIR and saved original SA modules of this drive. Now when I try to upload DIR and LDR in to the RAM it is going to ready state in normal mode. But I can not read user data at all. I took ABR error on every sector. Then I have realised that translator can not be read by any head but composite reading. I made manuel head test and head 1 can write more successfully. Then I tried to write translator with head 1 but it gives "Module : 31............................. : Module 0031 writing error ABA 5041 writing error Device Error Detected: "DISK SERVO WRT FLT OFFTRACK ERROR"" Any suggestions for me? Thank you. |
|
| Author: | pclab [ November 16th, 2020, 9:55 ] |
| Post subject: | Re: WD10JPCX-24UE4T0 / ROM FW 0016007C |
But head 0 is dead? If yes, you should do a head swap because even if you can solve the SA problem, you will get partial data and corrupted files. |
|
| Author: | datarikaviri [ November 16th, 2020, 15:36 ] |
| Post subject: | Re: WD10JPCX-24UE4T0 / ROM FW 0016007C |
pclab wrote: But head 0 is dead? If yes, you should do a head swap because even if you can solve the SA problem, you will get partial data and corrupted files. Yes but I want to get half of data at least firstly. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|