HDD GURU FORUMS
http://forum.hddguru.com/

Help]How do I load the translator to ram for spyglass drive?
http://forum.hddguru.com/viewtopic.php?f=11&t=43052		 Page 1 of 1
Author:  CrazyDoctor [ January 23rd, 2023, 17:55 ]
Post subject:  Help]How do I load the translator to ram for spyglass drive?
Hi all

Long time since I had to do this procedure so I lost the right steps. Please help me :)
I got WD40NMZW-11GX6S1-01.01A01 drive with bad pcb. After converting the USB to SATA and blocked module 02 access I got full SA access but no user data access.
How do I load or initilize the drive by loading the translator to RAM to get full drive ID?

I attending to this approche because the solution for slow responding drive may damage the original translator so I want to load the translator to ram and use the solve responding solution for the ram only.

I hope I succeed to explain myself.

How do I load the translator to ram for spyglass drive?

Best Regards,
Author:  pepe [ January 23rd, 2023, 19:02 ]
Post subject:  Re: Help]How do I load the translator to ram for spyglass dr
write it to ram.... but i doubt that would work after starting it with 02 blocked...
Author:  CrazyDoctor [ January 23rd, 2023, 19:48 ]
Post subject:  Re: Help]How do I load the translator to ram for spyglass dr
pepe wrote:
write it to ram.... but i doubt that would work after starting it with 02 blocked...


I solved the case,

Thank you pepe for your respond :)
Author:  fzabkar [ January 23rd, 2023, 20:32 ]
Post subject:  Re: Help]How do I load the translator to ram for spyglass dr
Did the original PCB have a dry solder joint at the zero-ohm resistor near the USB connector?
Author:  CrazyDoctor [ January 28th, 2023, 13:36 ]
Post subject:  Re: Help]How do I load the translator to ram for spyglass dr
fzabkar wrote:
Did the original PCB have a dry solder joint at the zero-ohm resistor near the USB connector?


I didn't check
I solved the case by converting the board to sata and did some modifications on the SA.
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/