All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 5 posts ] 
Author Message
 Post subject: Help]How do I load the translator to ram for spyglass drive?
PostPosted: January 23rd, 2023, 17:55 
Offline

Joined: February 15th, 2010, 23:14
Posts: 113
Hi all

Long time since I had to do this procedure so I lost the right steps. Please help me :)
I got WD40NMZW-11GX6S1-01.01A01 drive with bad pcb. After converting the USB to SATA and blocked module 02 access I got full SA access but no user data access.
How do I load or initilize the drive by loading the translator to RAM to get full drive ID?

I attending to this approche because the solution for slow responding drive may damage the original translator so I want to load the translator to ram and use the solve responding solution for the ram only.

I hope I succeed to explain myself.

How do I load the translator to ram for spyglass drive?

Best Regards,


Top
 Profile  
 
 Post subject: Re: Help]How do I load the translator to ram for spyglass dr
PostPosted: January 23rd, 2023, 19:02 
Offline

Joined: October 3rd, 2005, 0:40
Posts: 4311
Location: Hungary
write it to ram.... but i doubt that would work after starting it with 02 blocked...

_________________
Adatmentés - Data recovery


Top
 Profile  
 
 Post subject: Re: Help]How do I load the translator to ram for spyglass dr
PostPosted: January 23rd, 2023, 19:48 
Offline

Joined: February 15th, 2010, 23:14
Posts: 113
pepe wrote:
write it to ram.... but i doubt that would work after starting it with 02 blocked...


I solved the case,

Thank you pepe for your respond :)


Top
 Profile  
 
 Post subject: Re: Help]How do I load the translator to ram for spyglass dr
PostPosted: January 23rd, 2023, 20:32 
Offline
User avatar

Joined: September 8th, 2009, 18:21
Posts: 15461
Location: Australia
Did the original PCB have a dry solder joint at the zero-ohm resistor near the USB connector?

_________________
A backup a day keeps DR away.


Top
 Profile  
 
 Post subject: Re: Help]How do I load the translator to ram for spyglass dr
PostPosted: January 28th, 2023, 13:36 
Offline

Joined: February 15th, 2010, 23:14
Posts: 113
fzabkar wrote:
Did the original PCB have a dry solder joint at the zero-ohm resistor near the USB connector?


I didn't check
I solved the case by converting the board to sata and did some modifications on the SA.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 5 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 23 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group