This hard disk is nowhere to be found in hitachi utility , which family I should select.

Hitachi-IBM and then custom families

_________________
odzyskiwanie danych

But if you do not know what utility to open, what are you planning to do when you get sa access?
Seen 3 drives this week, where people with the right tools caused data loss, drive is just for training and not a client right?

_________________
Digitalsupport Data Recovery
https://digitalsupport.dk

First of all thank you digisupport
This is client disk ( a doctor) with important data. Though I am learning I will ensure that I will not cause any further damage.
I don't know how to access and work with SA (may be terminal adapater also might be needed)
I will be very cautious

Thank you melvin , at least now I can initialize drive with correct family.

[quote="digisupport"]But if you do not know what utility to open, what are you planning to do when you get sa access?
Seen 3 drives this week, where people with the right tools caused data loss, drive is just for training and not a client right?[/quo
With proper family selection I have got access to modules / Zone allocation table ,and I have taken backup as well.
Most of the critical modules are ok. Disk has 4 heads & while imaging selected data disk makes screeching noise and readyness is lost.
I could not see anything in utility to work on SA .
Since modules can be read and are working can we conclude this is due to platter degradation ?
There is no way to check Heads in utility.