HDD GURU FORUMS http://forum.hddguru.com/ |
|
Hitachi HTS 5450B9A300 correct Family in PC3K http://forum.hddguru.com/viewtopic.php?f=11&t=43840 |
Page 1 of 1 |
Author: | melvin [ November 18th, 2023, 2:16 ] |
Post subject: | Re: Hitachi HTS 5450B9A300 correct Family in PC3K |
Hitachi-IBM and then custom families |
Author: | digisupport [ November 18th, 2023, 4:15 ] |
Post subject: | Re: Hitachi HTS 5450B9A300 correct Family in PC3K |
But if you do not know what utility to open, what are you planning to do when you get sa access? Seen 3 drives this week, where people with the right tools caused data loss, drive is just for training and not a client right? |
Author: | MISU [ November 18th, 2023, 5:47 ] |
Post subject: | Re: Hitachi HTS 5450B9A300 correct Family in PC3K |
digisupport wrote: But if you do not know what utility to open, what are you planning to do when you get sa access? Seen 3 drives this week, where people with the right tools caused data loss, drive is just for training and not a client right? First of all thank you digisupport This is client disk ( a doctor) with important data. Though I am learning I will ensure that I will not cause any further damage. I don't know how to access and work with SA (may be terminal adapater also might be needed) I will be very cautious |
Author: | MISU [ November 18th, 2023, 5:48 ] |
Post subject: | Re: Hitachi HTS 5450B9A300 correct Family in PC3K |
melvin wrote: Hitachi-IBM and then custom families Thank you melvin , at least now I can initialize drive with correct family. |
Author: | MISU [ November 20th, 2023, 0:25 ] | ||||
Post subject: | Re: Hitachi HTS 5450B9A300 correct Family in PC3K | ||||
[quote="digisupport"]But if you do not know what utility to open, what are you planning to do when you get sa access? Seen 3 drives this week, where people with the right tools caused data loss, drive is just for training and not a client right?[/quo With proper family selection I have got access to modules / Zone allocation table ,and I have taken backup as well. Most of the critical modules are ok. Disk has 4 heads & while imaging selected data disk makes screeching noise and readyness is lost. I could not see anything in utility to work on SA . Since modules can be read and are working can we conclude this is due to platter degradation ? There is no way to check Heads in utility.
|
Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |