| HDD GURU FORUMS http://forum.hddguru.com/ |
|
| RayMX RM1135 http://forum.hddguru.com/viewtopic.php?f=11&t=44538 |
Page 1 of 1 |
| Author: | Core.iStores [ August 2nd, 2024, 11:30 ] | ||
| Post subject: | RayMX RM1135 | ||
i have a chinese SSD Sata and it has RayMX RM1135 when i connect it to the PC3K it reads it normally with all info but with reading is very very slow and when i repower the SSD manually it can read the unreadable sectors but very slow is there and suggestions to solve that ?
|
|||
| Author: | melvin [ August 2nd, 2024, 12:03 ] |
| Post subject: | Re: RayMX RM1135 |
No solutions for Realtek to work in techno mode. Copy important data as fast as possible. Set proper timing, resets, repowers etc. Try with a little heat or freezing spray on nands. |
|
| Author: | Amarbir[CDR-Labs] [ August 2nd, 2024, 12:05 ] |
| Post subject: | Re: RayMX RM1135 |
Core.iStores wrote: i have a chinese SSD Sata and it has RayMX RM1135 when i connect it to the PC3K it reads it normally with all info but with reading is very very slow and when i repower the SSD manually it can read the unreadable sectors but very slow is there and suggestions to solve that ? Hi, Cover the entire ssd leaving the nand chips ,Then use hot air or freeze whatever works .if reading is slow nand is degrading |
|
| Author: | Core.iStores [ August 2nd, 2024, 12:28 ] |
| Post subject: | Re: RayMX RM1135 |
thank you for your replays but i tried those suggestions it gives same results, it reads about 0.5 mb in 30 min 
|
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|