Change your SMPS (power Supply Unit).
This happens when your power supply is not working fine.
I recommend at least 600Watt SMPS. Coolermaster/ Antec/ Vantec.
DF
| HDD GURU FORUMS http://forum.hddguru.com/ |
|
| Problem with UDMA http://forum.hddguru.com/viewtopic.php?f=11&t=8861 |
Page 1 of 1 |
| Author: | dobrevjetser [ April 18th, 2008, 3:52 ] |
| Post subject: | Problem with UDMA |
Hi Friends, My PC3K UDMA behaves strange! All is fine when just one drive is attached, but as soon as i attach a drive to the second channel and power it, the drive on the first channel starts to click. I can read some data, then it clicks again after a few seconds, i can read again etc ... If i power the second drive down, no problem at all. Anyone who also experienced this ? I suspect a problem with the powerboard. Dobre |
|
| Author: | darkforce1 [ April 18th, 2008, 3:57 ] |
| Post subject: | Re: Problem with UDMA |
Change your SMPS (power Supply Unit). This happens when your power supply is not working fine. I recommend at least 600Watt SMPS. Coolermaster/ Antec/ Vantec. DF
|
|
| Author: | dmarques [ April 18th, 2008, 7:58 ] |
| Post subject: | Re: Problem with UDMA |
It's better, as I never had problems with UDMA like that. |
|
| Author: | Shortscurcuits [ April 28th, 2008, 0:40 ] |
| Post subject: | Re: Problem with UDMA |
Some newer power supplies have short circuit protection incorporated into v-reg, my main rig for drive recovery started having the same problem after I had to replace the power supply with an emergency backup after a power surge. I used to be able to change drives hotswap in XP, but now it bluescreens from the voltage drop when a new drive is plugged in. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|