| HDD GURU FORUMS http://forum.hddguru.com/ |
|
| Use Salvation Mods for PC3K http://forum.hddguru.com/viewtopic.php?f=11&t=9609 |
Page 1 of 1 |
| Author: | Shortscurcuits [ August 10th, 2008, 22:28 ] |
| Post subject: | Use Salvation Mods for PC3K |
Anyone figured out the module map for Salvation to use mods for PC3k. Have one Loader works same firmware and want to use these Mods with PC3K PCI to fix a 4R120L0 Post or PM if you can, need data so don't want to experiment with this one. Thx Andy |
|
| Author: | HardDiskBug [ August 11th, 2008, 2:10 ] |
| Post subject: | Re: Use Salvation Mods for PC3K |
So far, Seagate modules of salvationdata can be used with pc3k (And Vice Verca) and I have created a module conversion table for it too. But haven't experimented on maxtors yet.. If needed about seagates, welcome... |
|
| Author: | Shortscurcuits [ August 11th, 2008, 15:17 ] |
| Post subject: | Re: Use Salvation Mods for PC3K |
Thx HardDiskBug might come in handy if I ever fully figure out Seagates! It would be welcome if you want to PM it. I'll try to compare the maxtor modules in Winhex and will post a table when done if they work. Worth a try if I back up first. Was just hoping someone had done this already to save me a few hours headscratching. Thanks Andy |
|
| Author: | bunnydawg [ August 16th, 2008, 14:25 ] |
| Post subject: | Re: Use Salvation Mods for PC3K |
I"d read somewhere it was just renaming the modules to .rpm |
|
| Author: | bunnydawg [ August 16th, 2008, 14:26 ] |
| Post subject: | Re: Use Salvation Mods for PC3K |
Don't mean to post twice... did you work out a conversion thingy for that yet bug ? Thanks Robert |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|