How to determine the starting LBA of OD, MD and ID of a driv

Data recovery and HDD repair discussions

Switch to full style
In-depth technology research: finding new ways to recover data, accessing firmware, writing programs, reading bits off the platter, recovering data from dust.

Forum rules

Please do not post questions about data recovery cases here (use this forum instead). This forum is for topics on finding new ways to recover data. Accessing firmware, writing programs, reading bits off the platter, recovering data from dust...
Post a reply
wuming79
  • wuming79
  • Posts: 5
  • Joined: July 17th, 2012, 22:57
  • Location: Singapore

How to determine the starting LBA of OD, MD and ID of a driv

October 30th, 2013, 3:31

Hi,

Is it possible to determine the starting LBA of OD, MD and ID of a drive for different heads in the drives? I was tasked to write a script to check the start of the above but I am stuck at identifying the LBA at different location per head.
louis
  • louis
  • Posts: 209
  • Joined: August 22nd, 2011, 15:43
  • Location: Romania

Re: How to determine the starting LBA of OD, MD and ID of a

November 1st, 2013, 15:32

what's OD MD and ID?
Doomer
  • Doomer
  • Posts: 3577
  • Joined: September 29th, 2005, 12:02
  • Location: Chicago
  • Website

Re: How to determine the starting LBA of OD, MD and ID of a

November 1st, 2013, 17:47

OD - outer diameter
ID- inner
MD - middle

It's is only possible with vendor specific commands, unless it's a SCSI/SAS/FC drive
Post a reply
Switch to full style

Powered by phpBB © phpBB Group.

Board index