In-depth technology research: finding new ways to recover data, accessing firmware, writing programs, reading bits off the platter, recovering data from dust.
Forum rules
Please
do not post questions about data recovery cases here (use
this forum instead). This forum is for topics on finding new ways to recover data. Accessing firmware, writing programs, reading bits off the platter, recovering data from dust...
April 6th, 2011, 6:41
Friends,
I'm in a need of a oscillioscope, happily a small one for measure of the PCB, but I cannot find exactly what to look for. The frequency for the MCU, which is the fastest one, but do not know the mhz.
Please, if possible, could you tip me wich one and wich frequency I need to look for.
My best regards
Bobby
April 7th, 2011, 1:38
100 Mhz dual channel for pcb, DDA in the Ghz range if you want to snoop on read channel. 1000/2500 Eur the first, under 10.000 the second - diff probe required.
P.s. Forget Usb pc based. Get a decent and serviced scope like Tek, Hp, Agilent...
Powered by phpBB © phpBB Group.