In-depth technology research: finding new ways to recover data, accessing firmware, writing programs, reading bits off the platter, recovering data from dust.
Forum rules
Please
do not post questions about data recovery cases here (use
this forum instead). This forum is for topics on finding new ways to recover data. Accessing firmware, writing programs, reading bits off the platter, recovering data from dust...
December 27th, 2015, 12:27
Hello,
I'm new on this forum, but I think I'll find the answer here.
My Samsung have CRC errors, but I want reset his SMART.
But I have problem with his pinouts. Can anyone help me with this?
December 27th, 2015, 15:23
I will read this, thanks.
But port in my Samsung is not:
x x x x
but
X X
X X
so i dont know how connect RX and TX.
Drive have CRC error but since 4 years, their value has not increased and i want to reset SMART.
February 22nd, 2021, 0:30
hi, Spildit...
all the tutorials that I saw, teaches you how to clear the entire smart table...
my case is just a bad contact defect on the HDD PCB, which causes wrong information in the smart table, after I removed the bad contact, the increment in the table stopped happening and now I need to eliminate this number, because it is too big and system is accusing a problem in the HDD...
is it possible to clear just one information in the table and keep the other information intact?
February 23rd, 2021, 19:01
sure it is. Just need to find that value in the SA and modify it.
February 24th, 2021, 10:23
ok! thank you so much...
please, could you tell me which command to adjust only one parameter of the smart table?!
I know that need to use the terminal, through the HD serial port...
I just don't know, the commands that I should use!!
Powered by phpBB © phpBB Group.