Page 1 of 1
Wanted: PCB for WD800BB-00DKA0 (Board #: 2061-001159-100)
Posted: November 25th, 2008, 20:49
by beb0
It looks like the U7 chip got fried - causes a short and the power supply switches off immediately when the computer is turned on.
The sticker on the IDE port reads 2061-001159-100 BD1, while the numbers on the board itself are 2061-001159-003 REV P1.
Can any one help? Also, does anybody know whether I will need to swap the firmware chips on this one?
Thanks!
Re: Wanted: PCB for WD800BB-00DKA0 (Board #: 2061-001159-100)
Posted: November 25th, 2008, 22:53
by networkpc3000
hello,
i have this PCB, please contact me if you need.
sunnydreamspace@hotmail.com
Re: Wanted: PCB for WD800BB-00DKA0 (Board #: 2061-001159-100)
Posted: November 26th, 2008, 13:37
by pcimage
I have this PCB.
I also have a good ROM for the WD800BB-00DKA0 I can program the PCB with.
The PCB I send you will be tested with my known working WD800BB-00DKAO drive.
This "should" work for you, but if it doesn't you will have to move the 8-legged ROM chip from yours.
PM me if interested.
Re: Wanted: PCB for WD800BB-00DKA0 (Board #: 2061-001159-100)
Posted: November 26th, 2008, 18:01
by beb0
To all that replied - thank you. I need to make a small correction - the number on the board is 2060-001159-003 (vs. 2061-001159-100 on the sticker).
Re: Wanted: PCB for WD800BB-00DKA0 (Board #: 2061-001159-100)
Posted: November 27th, 2008, 6:49
by pcimage
I know it is!
Re: Wanted: PCB for WD800BB-00DKA0 (Board #: 2061-001159-100)
Posted: November 27th, 2008, 14:35
by rameez
I have it to .