hi,
everybody provide free examination. i have this service also. the point is how much for data recovery.
| HDD GURU FORUMS http://forum.hddguru.com/ |
|
| Looking for WD200JB 00DUA1 PCB http://forum.hddguru.com/viewtopic.php?f=15&t=13060 |
Page 1 of 1 |
| Author: | soundcatcher [ August 20th, 2009, 8:09 ] |
| Post subject: | Looking for WD200JB 00DUA1 PCB |
Hi my old WD2000JB disk has failed and from what I can gather from other posts I might be able to breath some life into it to get my data off it with a replacement board. Here's the disks details... MDL , WD2000JB - 00DUA1 DCM , DSBHNVJAH 2061 - 001160 - 100 D If you need any other info to work out if you have something that's compatable just ask..... The drive itself spins up sounding normal, does the usual sounding searching ticks and then shuts down. It's recognised by my PC and it starts to install the drive but the drive shuts down before the installation can be completed. So there you go I am either looking for just the logic board or an old used working drive that I can use for spares please. |
|
| Author: | pcimage [ August 20th, 2009, 14:10 ] |
| Post subject: | Re: Looking for WD200JB 00DUA1 PCB |
A PCB will not help you with this drive. |
|
| Author: | soundcatcher [ August 20th, 2009, 14:25 ] |
| Post subject: | Re: Looking for WD200JB 00DUA1 PCB |
pcimage wrote: A PCB will not help you with this drive. Fair enough...are you saying the only way I can retrieve the data is to give it to a specialist company??? Doesn't that cost a bomb?? |
|
| Author: | pcimage [ August 22nd, 2009, 11:10 ] |
| Post subject: | Re: Looking for WD200JB 00DUA1 PCB |
Not necessarily. We offer free examination if you care to send it down. |
|
| Author: | networkpc3000 [ August 22nd, 2009, 19:34 ] |
| Post subject: | Re: Looking for WD200JB 00DUA1 PCB |
hi, everybody provide free examination. i have this service also. the point is how much for data recovery.
|
|
| Author: | Eric Lee [ August 25th, 2009, 4:28 ] |
| Post subject: | Re: Looking for WD200JB 00DUA1 PCB |
Hi, I have this working PCB, if you need PCB only, I think I could help. Thanks Eric |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|