| HDD GURU FORUMS http://forum.hddguru.com/ |
|
| HDD PCB Needed Seagate 160GB http://forum.hddguru.com/viewtopic.php?f=15&t=18965 |
Page 1 of 1 |
| Author: | Halo-101 [ March 29th, 2011, 22:27 ] |
| Post subject: | HDD PCB Needed Seagate 160GB |
Seagate Barracuda 7200.7 160Gbytes Model:ST3160021A S/N:4JS0A4RC P/N:9W2001-373 HDA P/N : 100316342' Config: D11W-01 Firmware:8.01 Date Code:0544 Site Code:TK Main Chip #: 100319396 Board #: 100282774 A PCB Matching These Specifications Or The Ones Listed Here: http://www.onepcbsolution.com/seagate-b ... -2774.html Thanks in advance heaps if you can help me. |
|
| Author: | fzabkar [ March 30th, 2011, 4:08 ] |
| Post subject: | Re: HDD PCB Needed Seagate 160GB |
Can you describe the failure symptom? One of us may be able to help you repair your board, or at least confirm that the problem isn't elsewhere. |
|
| Author: | Halo-101 [ March 30th, 2011, 19:29 ] |
| Post subject: | Re: HDD PCB Needed Seagate 160GB |
It was being disconnected and reconnected from the pc randomly then when i pulled out the data cable it was smell of smoke plug back in and then it wouldnt read at all but still spin. |
|
| Author: | fzabkar [ March 30th, 2011, 20:59 ] |
| Post subject: | Re: HDD PCB Needed Seagate 160GB |
I can't understand why pulling out the data cable would cause the drive to smoke. It's quite possible that one or more signals on the IDE interface would have been damaged, though. I assume that you've switched IDE ports, just in case the motherboard was damaged as well as, or instead of, the drive. |
|
| Author: | Eric Lee [ March 31st, 2011, 2:34 ] |
| Post subject: | Re: HDD PCB Needed Seagate 160GB |
Hi, I have this working PCB in stock, pls contact my hotmail. Thanks, Eric |
|
| Author: | networkpc3000 [ April 11th, 2011, 3:29 ] |
| Post subject: | Re: HDD PCB Needed Seagate 160GB |
i have this PCB in stock. still need? you can contact me by email or skype. would you like to show me images of your PCB that we may help you without order a PCB. |
|
| Author: | Halo-101 [ September 16th, 2011, 6:16 ] |
| Post subject: | Re: HDD PCB Needed Seagate 160GB |
PCB Needed again if anybody has in stock willing to pay up to $40AUS ..... |
|
| Author: | Eric Lee [ September 18th, 2011, 8:39 ] |
| Post subject: | Re: HDD PCB Needed Seagate 160GB |
Hi, I have this working PCB in stock, pls contact my hotmail. Thanks, Eric. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|