| HDD GURU FORUMS http://forum.hddguru.com/ |
|
| Looking for a donor WD10EAVS HDD http://forum.hddguru.com/viewtopic.php?f=15&t=43176 |
Page 1 of 1 |
| Author: | transitNFCtech [ March 9th, 2023, 3:08 ] | ||
| Post subject: | Looking for a donor WD10EAVS HDD | ||
Is there a compatible donor HDD that is compatible with the following patient HDD? Patient HDD MDL: WD10EAVS-00D7B0 DATE: 15 MAY 2008 DCM: HHRNNT2CAB R/N: 701537 S/N: WCAU40285619 Drive Parameters: LBA 1953525168 1.0 TB
|
|||
| Author: | digisupport [ March 9th, 2023, 9:00 ] |
| Post subject: | Re: Looking for a donor WD10EAVS HDD |
I would just go for another Kermit drive with same headmap and usual matching parameters. Think Atlantis would fit to. Not sure what exactly you are asking about - please specify.. |
|
| Author: | transitNFCtech [ March 9th, 2023, 22:52 ] |
| Post subject: | Re: Looking for a donor WD10EAVS HDD |
digisupport wrote: I would just go for another Kermit drive with same headmap and usual matching parameters. Think Atlantis would fit to. Not sure what exactly you are asking about - please specify.. I am searching for an HDD that matches the specifications of the HDD shown in the picture and stated under the "Patient HDD" list as I am doing an HDD head repair. I only need good working heads. Based on this guide for choosing a donor HDD, I would need to at least match the model ID in the first part and the 'D7B' characters in the second part (top priority; preferably, the whole model ID to match), match the 'T2' characters in the DCM ID (high priority; preferably, the 'RNN' characters preceding the 'T2' characters to also match; ideally, the whole DCM ID to match), and match the physical heads (top priority; already opened the HDD as shown in the picture with visible screws; HDD configuration is 3 platters, 6 heads). Ideally, rather fully match all ideal donor HDD criteria to eliminate variables affecting HDD repair. Ideally, if it means lower costs, I would rather just only obtain the compatible donor HDD head so I can get the HDD in the picture to read the SA MODs for rewriting ROM MODs. Also, I prefer to pay in CA$ and head/HDD be located domestically (1st preference) or within North America (2nd preference; USA included). |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|