HDD GURU FORUMS
http://forum.hddguru.com/

Atola Imager fail to many issues
http://forum.hddguru.com/viewtopic.php?f=19&t=19540
Page 2 of 2

Author:  Dmitry Postrigan [ May 30th, 2011, 4:52 ]
Post subject:  Re: Atola Imager fail to many issues

Craig,

Thank you for the screenshots.

At the bottom right you can see four buttons. First three control Source HDD power (ON/OFF/CYCLE); the last one allows to power off the target drive. It was like that for a very long time; we did not change anything. You can downgrade to any previous version and verify that.

We plan to add Target Power ON button in the upcoming release.

Media recovery is not for data recovery; it is primarily for R&D (to be used together with Generate Bad Sectors). It can also be used to repair a few bad sectors on a hard drive without any data. It specifically says to not to use it for data recovery (see attached screenshot). Please do not use this feature in relation to any data recovery case; use imaging instead. If imaging does not work then Media Recovery won't be of any help.

Attachments:
media_recovery.png
media_recovery.png [ 84.62 KiB | Viewed 23764 times ]

Author:  craig6928 [ May 30th, 2011, 5:06 ]
Post subject:  Re: Atola Imager fail to many issues

yes i notice your screen is different from mine

im still on version 1.46.29611

so i got a older version still

not sure what happened as i did the full update.
when it asked for you to hold down the yellow source button on the drive

so it never updated at all :(


thanks

Author:  Dmitry Postrigan [ May 30th, 2011, 5:33 ]
Post subject:  Re: Atola Imager fail to many issues

Wow, that version is 1 year old. Current version is 2.1.

Try installing the latest 2.1 update again. Let me know if you run into any issue updating.

Author:  craig6928 [ May 30th, 2011, 5:46 ]
Post subject:  Re: Atola Imager fail to many issues

working fine now it updated.

going to pay for new updates this week.


thank you for all your hard work

dmitry

Author:  Dmitry Postrigan [ May 30th, 2011, 5:49 ]
Post subject:  Re: Atola Imager fail to many issues

You're welcome!

If you run into any issue in the future, just let me know.

Author:  techrxgb [ December 15th, 2013, 21:41 ]
Post subject:  Re: Atola Imager fail to many issues

Are you saying Imager or Bandura? I had the Target power go south on the Bandura. However, it was simply a surface mount capacitor that died, when investigated.

Author:  craig6928 [ December 16th, 2013, 1:21 ]
Post subject:  Re: Atola Imager fail to many issues

this is a old post everything is finer with the atola no issues

Page 2 of 2 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/