Page 1 of 1
ST lba 0 error
Posted: July 9th, 2013, 21:35
by nefli
Hi
I want to repair the lba 0 as shown in the salvationdata procedure,
I spin down, remove twezeer and spin up ok
but when i want to reset smart oups i receive the LED: 000000CC error
how to solve?
In Some cases of repair, i have a spin up error efter removing tweezers, what does means?
Thank you
Re: ST lba 0 error
Posted: July 10th, 2013, 6:39
by nefli
I'll try this afternoon
thank you very very much Spildit
Re: ST lba 0 error
Posted: July 10th, 2013, 14:12
by nefli
no way friend
still led error
thx
Re: ST lba 0 error
Posted: July 11th, 2013, 13:46
by nefli
It s a ST9120820AS fw 8.04
thank you
Re: ST lba 0 error
Posted: July 11th, 2013, 15:40
by pcimage
It just keeps repeating that?
Try new PCB. (Transfer rom)
Re: ST lba 0 error
Posted: July 11th, 2013, 19:16
by rameez
This drive is not F3 .
Do what pcimage said .
Re: ST lba 0 error
Posted: July 11th, 2013, 20:43
by nefli
thank you to all
i try to find a new pcb
i ll keep you informed
thanx
Re: ST lba 0 error
Posted: July 20th, 2013, 14:28
by nefli
Hello friends
i don t find a pcb to test yet!!!
thx
Re: ST lba 0 error
Posted: July 25th, 2013, 1:34
by craig6928
had same error and issue turned out to be a headstack fail.
replace headstack and works fine now
if swapping the rom over then that your issue for sure