Page 1 of 1
ST2000DL003 2TB Busy, No Spin, No Terminal
Posted: October 6th, 2018, 8:28
by shubhsinghal
PCB without HDA gives ready state. (Tried with Donor PCB + Patient ROM)
PCB with HDA gives busy mode.
By entering Bootcode mode, Model & Serial Visible with 0.00 GB and no terminal access.
Any suggestions?
Re: ST2000DL003 2TB Busy, No Spin, No Terminal
Posted: October 6th, 2018, 9:01
by data-medics
You can start by posting the terminal output you're getting when the drive starts up.
Re: ST2000DL003 2TB Busy, No Spin, No Terminal
Posted: October 8th, 2018, 3:05
by shubhsinghal
Terminal is total blank. No single output
Re: ST2000DL003 2TB Busy, No Spin, No Terminal
Posted: October 8th, 2018, 4:13
by shubhsinghal
No Spin, No Terminal, Busy Status.
Not able to read system Files as well.
Re: ST2000DL003 2TB Busy, No Spin, No Terminal
Posted: October 8th, 2018, 9:03
by pclab
It enters directly into BootCode mode??
Is the ROM original?
Re: ST2000DL003 2TB Busy, No Spin, No Terminal
Posted: October 8th, 2018, 9:31
by shubhsinghal
Yes ROM is original, Busy State so, only can enter bootcode mode.
Still Pending!!!