Page 1 of 1
ST3000DM001
Posted: August 17th, 2019, 17:35
by jonbang
Anything to do here? It spins up, click twice and spins down It gets ID, firmware etc, but says the size is 3,86gb. Is this dead or is there something i can do?
Re: ST3000DM001
Posted: August 17th, 2019, 18:06
by mhp666
Hi.
I think it is a lost case.
Every time the needles pass through that area I think they will break.
Also if I'm not mistaken, the other surfaces of the HDD have the same scratch.
A greeting.
Re: ST3000DM001
Posted: August 18th, 2019, 5:29
by MindMergepk
most likely gone, if customer is willing, partial recovery can be attempted...
Re: ST3000DM001
Posted: August 18th, 2019, 8:00
by pcimage
MindMergepk wrote:most likely gone, if customer is willing, partial recovery can be attempted...
Yes, maybe possible for partial but requires thorough investigation...
Not cheap
Re: ST3000DM001
Posted: August 18th, 2019, 12:54
by jonbang
MindMergepk wrote:most likely gone, if customer is willing, partial recovery can be attempted...
Ok, do you know how to partially recover? I have both mrt and pc3k available.
Re: ST3000DM001
Posted: August 18th, 2019, 12:59
by digisupport
jonbang wrote:MindMergepk wrote:most likely gone, if customer is willing, partial recovery can be attempted...
Ok, do you know how to partially recover? I have both mrt and pc3k available.
In your case I would remove top head, do the necessary ROM modifications to get the drive to start without h5
Re: ST3000DM001
Posted: August 18th, 2019, 13:01
by pcimage
digisupport wrote:jonbang wrote:MindMergepk wrote:most likely gone, if customer is willing, partial recovery can be attempted...
Ok, do you know how to partially recover? I have both mrt and pc3k available.
In your case I would remove top head, do the necessary ROM modifications to get the drive to start without h5
After checking all heads for debris under the microscope of course!
But in any case, it’s a cleanroom job.
Re: ST3000DM001
Posted: August 19th, 2019, 0:01
by digisupport
pcimage wrote:digisupport wrote:jonbang wrote:MindMergepk wrote:most likely gone, if customer is willing, partial recovery can be attempted...
Ok, do you know how to partially recover? I have both mrt and pc3k available.
In your case I would remove top head, do the necessary ROM modifications to get the drive to start without h5
After checking all heads for debris under the microscope of course!
But in any case, it’s a cleanroom job.
I take so many things for granted, thank you for completing my answer pcimage