Joined: September 21st, 2008, 8:08 Posts: 1 Location: Melbourne, Australia
|
Hello there,
You should check your bios for SATA configuration. If your SATA controller is set to RAID or ACPI, then change it to IDE while you are doing scans. The other thing to try is changing the SATA port the HDD is plugged into. I have Asus PK5R which has 4 Intel SATA ports plus 2 Jmicron SATA ports and 1 Dual channel PATA/IDE port. I can only see Sata drives on Intel ports 0 and 2. 1 and 3 do not display drives and the Jmicron SATA ports might as well not exist when using MHDD and other scanners.
Good Luck and please reply back if this works for you.
_________________ Data Recovery is FUN -- When it's not your data!
|
|