How to test for amount of cache on an HDD?
Posted: March 4th, 2011, 21:41
Hello Folks!
This is my first post here. I'm rather more advanced than most folks, but I would hardly say I'm a hard disk drive guru ... although I did write one or two disk drivers a long, long time ago.
I recently purchased a new Seagate Barracuda 7200.11 ST31500341AS 1.5 TB drive with CC1H firmware. The data sheet from Seagate (URL below) shows this drive as having 32 MB cache.
http://www.seagate.com/docs/pdf/datashe ... 200_11.pdf
When I run the cache test in HD Tune Pro v4.60 on the drive I get a (fairly) straight line across the top of the graph at 60 MB/sec. from 1 MB to 64 MB.
This would seem to indicate that the drive has 64 MB of cache.
Is there any other test I can run on the ST31500341AS that would TEST the drive for the amount of cache on the PCB? As a "non-drive-repair-professional" freeware or open source would be best as I'll likely only be using the recommended software once for this specific test. Any Windows / Linux / PC Unix suggestions would be welcome.
On the other hand maybe the PC build shop folks down the road a bit might have some other "normal payware" software that you folks could recommend. I might be able to swap something with them for such a small test.
I've spent multiple hours poking around the web and this website for clues about where to find such cache test software. If I've missed a posting on this website that already has this info then please point me to it.
Thanx.
This is my first post here. I'm rather more advanced than most folks, but I would hardly say I'm a hard disk drive guru ... although I did write one or two disk drivers a long, long time ago.
I recently purchased a new Seagate Barracuda 7200.11 ST31500341AS 1.5 TB drive with CC1H firmware. The data sheet from Seagate (URL below) shows this drive as having 32 MB cache.
http://www.seagate.com/docs/pdf/datashe ... 200_11.pdf
When I run the cache test in HD Tune Pro v4.60 on the drive I get a (fairly) straight line across the top of the graph at 60 MB/sec. from 1 MB to 64 MB.
This would seem to indicate that the drive has 64 MB of cache.
Is there any other test I can run on the ST31500341AS that would TEST the drive for the amount of cache on the PCB? As a "non-drive-repair-professional" freeware or open source would be best as I'll likely only be using the recommended software once for this specific test. Any Windows / Linux / PC Unix suggestions would be welcome.
On the other hand maybe the PC build shop folks down the road a bit might have some other "normal payware" software that you folks could recommend. I might be able to swap something with them for such a small test.
I've spent multiple hours poking around the web and this website for clues about where to find such cache test software. If I've missed a posting on this website that already has this info then please point me to it.
Thanx.