Hello. I am new to this forums so this topic may have been covered and I just did not see it.

I have used HDD's Low Level Formater software for some time on a computer running Vista. I just upgraded the OS (Clean Install). I installed the HDD Formating software and it worked fine for a few days. The other day when I opened up the software, the software did not show any of the hard drives on the system. I uninstalled the software and reinstalled the software, and it worked fine. The problem is that the min I close the software after it has been installed and then reopen it; the software does not show any hard drives including the system drives.

Any sugestions will be greatly appreciated.

Thank you for your time.

Comptec.

For the archives, the OP has repeated the same question here:

problems-with-hdd-low-level-format-software-t19292.html

Therefore this thread should not be used, to avoid duplication with the above linked thread.