Please, lets read my initial post again:
Quote:
Hi friends, i am interested on buy a seagate hdd refurbishing software tool.
I know about some tools, but capabilities of decrypting new models and depoping heads are limited to few models only. I am thinking on tool capable of full recertifying as many models as posible, and also the best support service.
It is a DFL-SRP USB3.0 Seagate Firmware Repair Tool a good choice?
So:
1- I am talking about seagate only.
2- I am talking of decripting new fw (like ST1000DM003, ST1000LM035....), depoping heads (for 7200.14 for example), playing with bad zones... Nothing of this can be done by terminal commands!!!
3- I'm asking for opinions about DFL, no one has talked about it....
Spildit:
Quote:
I can't see how DFL will be any better than even manual terminal command to "refurb" F3 arch drives .... Of course assuming you are not cutting heads ....
You assuming wrong, i am talking about cutting heads, backup and decripting fw, and much more...
Quote:
At any rate if you were able to refurb so many drives from so many brands without any tools then congratulations.
I was able to repair many hdds, but unable to repair many others... I can give you more stadistics: Without pro tools 2-3 out of 10 hdds, with Sediv almost 5 hdds out of 10 and for WD in particular may be even 6-7 out.
I don't know why you put negative in this topic