Page 1 of 1
IDE Grab
Posted: March 23rd, 2007, 18:01
by rameez
IDE Grab
What does this software do ?
please brief a little i have it downloaded but dont know what it does plus there is no manual with it .
Posted: March 23rd, 2007, 20:45
by Doomer
This is not only software
This is hardware and software
This device can monitor and log every command is sent to a drive
Posted: March 24th, 2007, 2:14
by rameez
Hardware where is the hardware and how can i get it plus can i identify problems with the hdd pcb with IDE Grab.
Posted: March 24th, 2007, 2:27
by friend
rameez wrote:can i identify problems with the hdd pcb with IDE Grab.
Simple answer is NO..
Posted: March 24th, 2007, 2:45
by rameez
so what can i use it for ??
Posted: March 24th, 2007, 6:33
by roodzeek
To look for ATA commands used by manufacturer's diagnostic utilities for example.
Posted: March 24th, 2007, 10:48
by Doomer
rameez wrote:Hardware where is the hardware and how can i get it
DIY
PCB schema should be on a site where you got software
Posted: March 25th, 2007, 4:15
by rameez
i will check it thanks for reply .
Posted: March 31st, 2007, 7:58
by bubu321
