Haven't used it for years....Seems to screw up a lot on anything over 1TB.

_________________
Buy your friends Toshiba\Hitachi and your enemies Seagate.

I have registered version , software works on some drives very well ( I use it for reverse cloning on SMART corrupted drives) ,However sometimes I notice partitions alignment issues. Same disk if cloned using DMDE or ninja gives different layout.
Its strange how cloning is done by different techniques. I have never been lucky to get a succcessful cloning using Udma though.

_________________
http://www.northwind.gr
SandForce SSD Recovery
Ransomware Reverse Engineering - NoMoreRansom! partners

drc, It looks like it since there is no info about programming this AMTL micro controller to work with Tetroniks HDDUP software anywhere to be found.I made the Power controller board exactly as it was described in their documented manual that comes with the software and since AT90S2313 controller is not programmed it is not functional.The only thing I don't understand is, why they gave all the information out regarding designing the circuit board and they didn't mention that it doesn't work without programming the AMTL microcontroller and as a matter of fact they even wrote software itself would initialize the Micro controller. Such a shame

drc, It looks like it since there is no info about programming this AMTL micro controller to work with Tetroniks HDDUP software anywhere to be found.I made the Power controller board exactly as it was described in their documented manual that comes with the software and since AT90S2313 controller is not programmed it is not functional.The only thing I don't understand is, why they gave all the information out regarding designing the circuit board and they didn't mention that it doesn't work without programming the AMTL microcontroller and as a matter of fact they even wrote software itself would initialize the Micro controller. Such a shame

Email support@hddpros.com if you need the code...

_________________
Buy your friends Toshiba\Hitachi and your enemies Seagate.

Thanks thatdellguy,
I E-mailed them and got the code and I downloaded into the microcontroller “ AT90S2313-10PC “ but it didn’t work, should I do anything else except loading the code I am using “ avrdude “ to program the chip. Thank you for your help.