MER Programmer 2.0

[Adam112255]

I have programmer 2.0 and it has troubles unlocking firmware after reading the ROM chip. has anyone faced same issue? tried to contact MRT they said Programmer 3.0 Is required. I was wondering if there is any way that can unlock with 2.0?

thanks

[ccc]

You will need MRT 2171 old version....read here
https://forum.hddguru.com/viewtopic.php?f=28&t=41721

Rgds

[Amarbir[CDR-Labs]]

You will need MRT 2171 old version....read here
https://forum.hddguru.com/viewtopic.php?f=28&t=41721

Rgds

MRT Said This " 3. Fixed the problem about failure to unlock PCB 810035. For version 2173 we need to choose 800022 to unlock 810035 "

[ccc]

MRT Said This " 3. Fixed the problem about failure to unlock PCB 810035. For version 2173 we need to choose 800022 to unlock 810035 "

Since MRT 2171(new) version to unlock a WD ROM we need the MRT ver 3.0 programmer...The OP does not have that programmer...That's the discussion here. Not the bugs in the software..

BTW. Do you have MRT programmer ver 3.0?

Rgds

[Amarbir[CDR-Labs]]

MRT Said This " 3. Fixed the problem about failure to unlock PCB 810035. For version 2173 we need to choose 800022 to unlock 810035 "

Since MRT 2171(new) version to unlock a WD ROM we need the MRT ver 3.0 programmer...The OP does not have that programmer...That's the discussion here. Not the bugs in the software..

BTW. Do you have MRT programmer ver 3.0?

Rgds

Hi,
I have super duper Elnec programmers ,So i just remove chip ,Read ,unlock and solder again .

[Adam112255]

You will need MRT 2171 old version....read here
https://forum.hddguru.com/viewtopic.php?f=28&t=41721

Rgds

Thanks I will try it. for now MRT said I can send them the files after I remove the chip from the board, read it and sent it to them they will unlock and send it back to me. I will order the programmer eventually.