August 8th, 2023, 12:31
August 10th, 2023, 6:30
August 10th, 2023, 15:19
August 10th, 2023, 15:52
August 10th, 2023, 16:51
August 11th, 2023, 5:21
August 11th, 2023, 5:58
August 12th, 2023, 8:32
Drive AMPS Configuration has been modified from compiled defaults.
Drive must be re-initialized to controller firmware defaults by re-downloadingcontroller firmware
August 12th, 2023, 20:08
August 13th, 2023, 5:25
April 20th, 2024, 19:31
Weckschmeissen wrote:Hello,
i want to try to reanimate a Seagate-drive, probably the well-known stuck in BSY-state-problem, like this: https://sites.google.com/site/seagatefix/
My equipment:
- PC with Windows XP 32bit
- USB to TTL-adapter with different voltages (1.8, 2.5, 3.3, 5.0 volt) and FTDI-chip
- TTL-adapter with fixed voltage at 5V.
My problem: It is impossible to get answer via TTL in terminal with ANY harddrive after CTRL+z. Loopback test (RX and TX connected at adapter) was successfull with both adapters.
My questions:
- i connected RX to TX and vice versa
- RX at HDD is nearest to S-ATA-connector, right?
- which voltage is correct?
- terminal is configurated to: Baud 38400, Data Bits: 8, Stop Bits: 1, Parity: none, Flow Control: none
- the same settings can also found in "device properties" (virtual COM found in "device manager"), which settings are here correct?
- has GND at HDD connected to TTL-adapter? Found some manuals with and without, some use 2 wires, others 3.
- has a non-US keyboard layout any effect?
Thanks in advance!
May 9th, 2024, 7:11
Powered by phpBB © phpBB Group.