Hello Guys,
as you know, these helium drives are not supported by any DR-Solution. But with a few Seagate Helium Drive Models the F3 Utilility of PC3K is capable to edit headmap in ROM. It is unfortunately not possible with this model.
This Drive makes constantly calibrating sounds and sounds like it will become readable. It gets full ID but as i know, this is only ROM related. After some seconds it gets ready state, keeps spinning, but there is no sector-access or anything else possible. Terminal Output as follows:
Quote:
Boot0x0100MAA0053SN03Motor startedHeads loadedHPSR[LBA=0x0000000000000105]N??+
UnrecoveredSeekHandler
UnrecoveredSeekHandler
UnrecoveredSeekHandler
UnrecoveredSeekHandler
UnrecoveredSeekHandler
UnrecoveredSeekHandler
UnrecoveredSeekHandler
UnrecoveredSeekHandler
UnrecoveredSeekHandler
UnrecoveredSeekHandler
UnrecoveredSeekHandler
UnrecoveredSeekHandler
UnrecoveredSeekHandler
UnrecoveredSeekHandler
UnrecoveredSeekHandler
UnrecoveredSeekHandler
UnrecoveredSeekHandler
UnrecoveredSeekHandler
UnrecoveredSeekHandler
UnrecoveredSeekHandler[LBA=0x0000000000000105]NO0;
SimError-RemaininginBootFW
Performadoubledownloadwithoutapowercycle
When i load the ROM-Image i get "WARNING! Segment used space check sum is invalid!" message of PC3K. When i patch the ROM to unlock techmode, then drive doesn't spin on and Terminal shows constantly:
Quote:
Flash boot code Digital Signature Verification failure!
Flash boot code checksum failure!
SEA3 Boot ROM 2.0 (08/01/2016)
Copyright Seagate 2016
So question is: please see the attachment, maybe there is any chance to edit headmap or unlock techmode...?! Or somebody wants to share their experiences regarding headswap for this model?! Any chance without reinsert helium and seal it again?
Thanks in advance.