hi to all

i have a maxtor with very badsector but sa is tru
i done selftest prosses

load ldr is safe mode with chksum E7CF => utility start

also (chesum sa is E7CF)
ctrl+alt+3 (selftest)=> launch selftest =>after swithing on

then power off => power on
load ldr and check box self test monitoring then utility start
then ctrl+alt+3 (menu self test) and monitoring
but unfortunatly first led blinking and drive drd dsc after afew minute bsy and led is on !!?
pls help
with tanks for your answere

i'm so sorry for bad english

_________________
NS DATA RECOVERY
www.nsrecovery.ir

i have try two another hdd 40 ares 64
this on selftest start and continues but other hdd again DRD DSC and then BSY

i have checked sa structure ,sa surface is ok !!

pls guide me
why dont start selftest,

thanks for u answere

_________________
NS DATA RECOVERY
www.nsrecovery.ir

did you try 'SA Surface Verification' with Remap option on?

thanks for yor replay

but i have tested 'sa surface verificaton ' was good ,sa no bad sectors
surface hdd is scratched and have very bad sectors

_________________
NS DATA RECOVERY
www.nsrecovery.ir

repeat again with another hdd ares 64 !!!? DRD DSC then BSY

but that hdd 40 start to selftest stop in test 67 first led on and then off 4 hourse later

step number test number
67 0075

pls,guide me masters hdd ??

i replaced pcb but again BSY

any oher person exprinced BSY?


with tanks for u attention

_________________
NS DATA RECOVERY
www.nsrecovery.ir

time solved the problem!!?
i told my hdds scratched when logical scan (in pc3000) on bad sectors power off and power on then continues how self scan could removed this bad sector on
surface disk

_________________
NS DATA RECOVERY
www.nsrecovery.ir