Hello everyone,
I have a 2000GB Seagate Barracuda HDD, that suddenly stops working. I try to repair it with terminal and USB->TTL connection, but the terminal always stuck on SATA Reset.
Then I try to find another board with same ID and REV, swapped bios chip, but the problem persists. If I Put the bios chip from donor HDD to Board from faulty HDD and this combination insert into donor HDD, the donor HDD works, so error is not in board, but deffinitively in bios chip. What can I do? I included log from terminal and images, the drive on the left is the bad drive.
Thanks for any suggestions and sorry for my bad english.
![Smile :)](./images/smilies/icon_smile.gif)
Images:
![Image](https://preview.ibb.co/cjOVVy/IMG_0938.jpg)
![Image](https://preview.ibb.co/cyHqVy/IMG_0939.jpg)
![Image](https://preview.ibb.co/cxptiJ/IMG_0940.jpg)
![Image](https://preview.ibb.co/n3NPqy/IMG_0941.jpg)
Log from some attemps in terminal:
Boot 0x40M
Spin Up[LBA=0x000042F9]N01010C10o0o0o0o0o0o0o
Trans.
Spin Up
SpinOK
SnapshotEventOccurred( SNAPSHOT_INITIAL_VALUES ).
(P) SATA Reset
Boot 0x40M
Spin Up[LBA=0x000042F9]N01010C10o0o0o0o0o0o0o0o0[LBA=0x000042F9]NO11
Trans.
Spin Up
SpinOK
SnapshotEventOccurred( SNAPSHOT_INITIAL_VALUES ).
(P) SATA Reset
Boot 0x40M
Spin Up[LBA=0x000042F9]N01010C10o0o0o0o0o0o0o0o0
Trans.
Spin Up
SpinOK
SnapshotEventOccurred( SNAPSHOT_INITIAL_VALUES ).
(P) SATA Reset
Boot 0x40M
Spin Up
Trans.
Spin Up
SpinOK
SnapshotEventOccurred( SNAPSHOT_INITIAL_VALUES ).
(P) SATA Reset
Boot 0x40M
Spin Up[LBA=0x000042F9]N0
Trans.
Spin Up
SpinOK
SnapshotEventOccurred( SNAPSHOT_INITIAL_VALUES ).
(P) SATA Reset
Boot 0x40M
Spin Up[LBA=0x000042F9]N01010C10o0o0o0o0o0o0o0o0
Trans.