Good place to start
Forum rules
No new topics are allowed in this forum. Please use other forums to create topics.
August 6th, 2007, 3:07
Does anyone know how to set Maxtor Calypso DiamondMax Plus 9 SATA safe mode? I got IDE diagram for safe mode but not SATA
Thanks
August 7th, 2007, 23:40
Here is the hdd
- Attachments
-
August 8th, 2007, 9:55
hi Real_Jose_Pinto, the easy motherd is replace one IDE PCB, like pcba_pn lable is R5FYA.
wawalab
good luck
August 8th, 2007, 11:15
Like Starling said in another post....
It does work!
August 8th, 2007, 11:30
It does work for sabre not calypso
August 8th, 2007, 11:52
It does, I just tried it with a 6Y160M0
msn me for details
August 8th, 2007, 20:48
I could not get it working, i did set jumper as shown by Starling but the motor still spins.
August 9th, 2007, 5:33
Hmm, that's strange. I just tried it again. Works fine.
Electronic "noise" comes from the PCB, but motor does not start, for me.
Load loader (takes up to 1 minute), then motor starts and all OK.
Check the pins again, I see your pic is upside down from Starlings drawing.
August 9th, 2007, 12:51
i have tried replacing the sata pcb with ide pcb both having same processor chip works good for me .
August 11th, 2007, 15:14
Hi Mates,
You people have so many Maxtors in your country.We Poor Mortals Have Very Very Less Maxtors .
June 28th, 2009, 20:09
@Real_jose_pinto...can you give me diagram for calypso diamondmax 9 IDE safe mode? or point me to someplace i can find it. thanks in advance.
Powered by phpBB © phpBB Group.