My Hard Disk Is :

ST500DM002
Firmware : KC44

IN The Bios Is identified , In Windows No Detected !!!!!

After Connect By TX And RX Controller Reply This Error :

Boot 0x10M
Spin Up[0x00000000][0x0000B67C][0x0000BA10]
Trans.

Rst 0x10M
MC Internal LPC Process
Spin Up
(P) SATA Reset

help pelease!

Is this your drive? If yes, then you perhaps know what has been happening with the drive.. any noticeable change in the drive's behavior prior to no longer working properly?
Have you attempted to enter in diagnostic mode?

_________________
Hard Disk Drive (HDD), Solid State Drive (SSD, SATA, NVMe, etc), USB Flash Drive and RAID Data Recovery Specialist in Massachusetts

Does "Partition Find and Mount" detect the drive? I have had a surprising run of results using this software including a Seagate drive which I personally almost botched up through the terminal, and was barely working in windows, and a Sandisk microSD that wasn't working in windows, apart from being detected.