Hi,
i try today to swap my pcb from one ST3100528AS to another.
if i put power on the harddrive beginning to start and make rhymtical clickin' noiseses...
the pcb i put on the harddrive is working 100 percent - it have the same type number.
0912-23-18 GRC 18 V-0 - 100536501 Rev A
so what i must do to make it work?

Kind Regards

Previous post:
viewtopic.php?f=1&t=30088

I just did one of this model today...only had about a dozen read errors after it was cloned. I saved the ROM from the patient and donor PCBs, using PC3K. Then I wrote the patient ROM to donor PCB.

Just remember, the ROM on the PCB is unique to the drive. If you accidentally damage it, it is game over.

_________________
Luke
Recovery Force Donor Inventory: 5,000+ Fully Cataloged HDDs & Growing

how do you realize the connection from the flash?
over TTL? or do u use a direct connection to the flash chip over soic grabbers?

Greetz

Just as I said, using PC3K. Am I correct in assuming that the data isn't worth $350? You get it yourself, you save a few bucks...you make a simple mistake and the data is lost forever or the cost ends up being 10 times the price.

_________________
Luke
Recovery Force Donor Inventory: 5,000+ Fully Cataloged HDDs & Growing

This company will do it for you for US$29:
http://www.onepcbsolution.com/firmware- ... t-pcb.html

_________________
A backup a day keeps DR away.

okay - many thanks for the tips guys!!
i will join the chaos communication congress in hamburg,
maybe i will found someone with this equipment there
(or i will use the service from the website).

Greetz

You can move over the ROM chip if you have soldering skills and are able to identify which chip it is. It's an 8 pin chip, if you upload a picture we can help you identify it.

_________________
Data Medics - Hard Drive, SSD, and RAID Data Recovery Service Company

"BIOS" IC:

http://ep.yimg.com/ay/yhst-144375849714 ... 1157-7.gif

_________________
A backup a day keeps DR away.

hey,
have a 16 pin soic testclip ...
http://www.mouser.de/ProductDetail/Pomo ... lNkg%3D%3D
... which fits on the 8 pin chip (the distance between the legs of the chips fits).

So i can transfer the bios from one pcb to another without soldering.
http://pdf1.alldatasheet.net/datasheet- ... LSNIG.html
found this technical papersheet - there is a pinout on page 5.

i will try this out tonight or tomorrow...
thank u guys for your incredible help!!

Dear Guys,
i swapped the pcb bios from one board to the other.
now the harddrive take a run-up.
but the partions are not detected - the harddrive makes a beeping noise.
i make a recording of the noise + upload the bioses:
http://www78.zippyshare.com/v/12019929/file.html

Hope someone can help along.

Merry Xmas!
Greetz

Is it detect in the BIOS with proper ID and capacity?

_________________
My firmware database:
https://mega.nz/folder/O01DkBRI