Hello,

I am Using the Seagate TOOLS from salvation data.

And i have this case.



How can i correct this problem to get data back.

Thanks
Jose

_________________
ZeBong
" что случилось в России - останется в России "
" Россия еще раз"

well the ihdd its identifies so means, the recalibration its OK, and its detected ID, so its getting DRD DSC

U need to check on Terminal , to know what´s happening and type some test commands to know , if its loaded Cert tables, for example, thats 0 size looks like SCSI 0 size problem, on Seagate Chettah, maybe translator corruption. but should be checked SA ,or maybe Bad head but thats should be checking with tests to know where its the problem.


Best regards

Alberto from Mexico

Hello,

When i make CMD MODE

it appers just this

F3 T>


Do You Know what is it ?
Wich command should i use.


Thanks
Jose

_________________
ZeBong
" что случилось в России - останется в России "
" Россия еще раз"

On that screen turn off and turn on and post it, the log, wich its showing

Some like that

Interface task reset
1024k x 16 SDRAM
TONKA2 - 1_Disk M-31 12-07-05 09:13

Buzz - Head Mask FFFF - Switch to full int.
Spin Ready
(P)PATA Reset

Thanks Beto,

When i connect the SEAGATE Doctor from salvation to the CMD MODE,

Nothing happen.

Is any other way to connect a disk via COM PORT?

Thanks
Jose

_________________
ZeBong
" что случилось в России - останется в России "
" Россия еще раз"

Wich model is your hdd,? there are some hdd´s 1 TB wich are not detected by normal terminal because use a technology similar SCSI

Best Regards

Here is the foto off the disk.






Can i change the PCB and the disk it will see the data ?

Thanks
Jose

_________________
ZeBong
" что случилось в России - останется в России "
" Россия еще раз"