Data recovery and disk repair questions and discussions related to old-fashioned SATA, SAS, SCSI, IDE, MFM hard drives - any type of storage device that has moving parts
February 19th, 2009, 4:46
If yes, how to know for next time? Witch parameters must be the same.
Thx
February 19th, 2009, 5:47
I believe heads are compatible, PCB is not.
February 19th, 2009, 6:15
I just done a head swap on one of these and when powered it tried aquiring then clicked. I left it clicking for 5 then it came ready and scanned fine.
February 19th, 2009, 6:21
PBC in theory is correctly...
There's anyway to know if heads are compatible even the PBC? Do you check by P/N?
February 19th, 2009, 6:55
Everything is INSIDE the drive.

something OUTSIDE

otherwise try...try...try on your own.
February 19th, 2009, 7:07
Same family, same code for heads (T166S), assuming head map is same (probably is), then head swap should work.
But like BlackST says, try it. Let us know here
February 19th, 2009, 7:10
Then let's make a Good speaker when head replacement fail

.
Ok ok, will try in 2 hours and tell you how it goes...
February 19th, 2009, 13:17
Bad luck. The patient has a ring on the top, so we will wait until next patient come...
Powered by phpBB © phpBB Group.