Dna0

Data recovery and HDD repair discussions

Data recovery and disk repair questions and discussions related to old-fashioned SATA, SAS, SCSI, IDE, MFM hard drives - any type of storage device that has moving parts
Post a reply
DiaaDms
  • DiaaDms
  • Posts: 10
  • Joined: May 31st, 2007, 10:14
  • Location: Egypt
  • Website

Dna0

June 23rd, 2007, 20:13

i have wd hdd itis spindle chip burned L6278 1.7E and R120 itis called at board R69 when i change L6278 1.7E and change R120 it burned again so where is problem
CK
  • CK
  • Posts: 872
  • Joined: March 13th, 2005, 12:33
  • Location: Dublin

June 23rd, 2007, 20:43

Sounds like a faulty motor which is drawing too much current through the PCB and continually blowing your motor controller chip.
rchadwick
  • rchadwick
  • Posts: 935
  • Joined: December 23rd, 2006, 16:08
  • Location: NJ

June 23rd, 2007, 22:32

It might be a frozen spindle too. I have one that burned out the motor chip. When I replaced it, it immediately gets hot. Doesn't get hot when PCB is on another drive...
Mikippp

June 24th, 2007, 13:36

Hi,
R69 is located in the -5V DC-DC converter...
If R69 is damaged -> check Q3, U9, L7...

Mikippp
Image
Amarbir[CDR-Labs]

June 24th, 2007, 17:20

What is U9 IC
rameez
  • rameez
  • Posts: 2288
  • Joined: June 27th, 2006, 11:33
  • Location: In ur HDD !

June 26th, 2007, 13:20

U9 is the address of the IC , which is mentioned on the pcb .
Post a reply
Switch to full style

Powered by phpBB © phpBB Group.

Board index