Hello guys,
want to ask You a question related to MHZ2160BH disk, there is a G1 and G2 version.
Does anybody know if PCB in these two models are interchangeable ?
I've got MHZ2160BH G1, it's hard to find the exact donor with matching firmware, I found the G2 version with the same firmware and I am curious if can I use its PCB to verify if the damage is related to PCB?

By the way, a propos the MHZ2160BH G2 version, please take a look to the picture below.
There is a weird nomenclature on the label - I marked it in red.

Thanks in advance for reply.

Yes, for this model they are. You can use it to check if PCB is at fault.

Can anyone tell me what the G1 and G2 indicates? Firmware?

I have a MHZ2160BH G2 drive with bad heads.. am planning to swap Platter from that drive to another new/working Fujitsu 160gb drive (luckily it's a single platter drive).
Do i have to match just MHZ2160BH or does it require G1 and G2 to match too?
I need that data (almost drive full)

VoodooPL, do u have a spare drive with bad PCB and good interior?