Hi guys,

I"m litter speak Enhlish, sorry.
I see many cases with no solutions. Can someone help me teamviewer ? please (Yahoo chat: khoiphucdulieu)

I have a Seagate Barracuda HDD not detected bios:
Family: 7200.12
Model: ST3250318AS
Size: 250Gbytes
Firmware: CC37
Product of China
When I looked in the BIOS model, saw that my Seagate HDD was recognized as 0MB and 0LBA!!

I have tried with dku5 and PC 3000 : but failed (

AND I"M TRIED COMMAND :


I tried but not
COMMAND: V4, V1

_________________
VERY HAPPY Email WITH ME: khoiphucdulieu@yahoo.com

Can someone help me ?

_________________
VERY HAPPY Email WITH ME: khoiphucdulieu@yahoo.com

Disconnect the PCB from the hdd, connect PCB only to terminal, Power ON

wait for Prompt, then try Ctrl-Z (stop motor) wait after it stops for min. 2-3 min.
then connect PCB back and be careful while doing so.

then, Ctrl-U ( level 2 /2)

then /1 U and wait for another 2-3 min after it does so then clear smart as you tried again
and post results back here

good luck

_________________
Kuwait Data Recovery - UNIX GTC
The only reason for time is so that everything doesn't happen at once. By: Albert Einstein

Normally with PC-3000 the ES2 manual will go through this one nicely for you. It will show you what needs to be done plus in the scripting of the UDMA there is a nice scrip to handle this one. What version of PC-3000 do you have and use? Is it PCI or UDMA version on this one? If it is older model then no it does not have the script for you and you will need to do a different step on this one. Try to download the Seagate ES2 manual from your download box

_________________
Iorana Haraharaini

DId the both of you see "FAILED TO LOAD OVERLAY 00000004" ?

Hi to all the forum!

What about 7200.12 that at power on + Ctrl-Z show this


please note that is stays bricked at line
(P) SATA Reset

and doesn't show the prompt again.

I tried the sequence for the SIM error, it has been hard to get the prompt, but finally I've been able to issue both the commands and both succeeded, but after power cycling the drive, it went again into



Thank you for any tip, hint, answer or help

Cor
(to PM me click here)

--------

are u able to get the terminal after this?

_________________
Kuwait Data Recovery - UNIX GTC
The only reason for time is so that everything doesn't happen at once. By: Albert Einstein

No it is hanged.

I've found one trick to get it but this won't help, 'cause as said above, the commands are successful, but the disk is still bricked.

Sorry for the delay in this answer

Cor