(if the data is important you should send it to a pro).
kisanth wrote:Brought computer out of standby, the system BSOD.
Ok, so was the computer in transport during the standby? If so it sounds like the drive failed on power up after standby - the pc bluescreened because
there was no active filesystem to read/write to. 0x000000007b is typical in those situations.
Do you have the bluescreen #'s?
If the lenovo diags fail you most likely have a serious drive problem.
Is there any smart data inside of the diagnostic?
Can you run a hitachi diagnostic?
There is a slight chance the drive may not be making good contact inside the unit however the chances of that are extremely slim to none if bios detects a hard drive. (bad memory can cause a system to act erratically but again - i doubt that in this situation - you can run a memtest (
http://www.memtest.org) and verify good memory.)
I'm not familiar with Utimaco, Does it allow you to boot off of a CD after it loads?
Without more information it sounds like drive failure (internal/pcb).
When you see that it couldn't load C:\windows\system32\config. Windows has started to boot but cannot read certain areas of the drive and or the registry hive is corrupted. (there is usually backups and or system restores that you could move back to get it going again, if the drive was functional)