Question guys

if you look @ the 2 places where the USB mini goes which is Broken connector

i tried to follow the points trying to solder ext. wires to it, but the problem is that it is too damn tight

even i tried to pull a wire from the 2 points but too damn small hole

my question is: is there any soldering material which fills those empty broken places (brown) ?
or any other technique?


thank you

_________________
Kuwait Data Recovery - UNIX GTC
The only reason for time is so that everything doesn't happen at once. By: Albert Einstein

wirewrap wire

_________________
A backup a day keeps DR away.

Hi, I would have thought for recovery purposes you can solder directly to what look like 2x inductors. Not sure what the other component is closer to the 2 broken pads but it might be a ferrite bead.
It dosn't look too hard from here! You just have to use the good magnifying lamp, the correct tip on your iron & a good quality solder. Maybe use kaynor wire though not always necessary.

thank you guys, will go through it again

my soldering skill were so bad, but now big Diff. heheh

thnx again

_________________
Kuwait Data Recovery - UNIX GTC
The only reason for time is so that everything doesn't happen at once. By: Albert Einstein